Glue in Top Lining and Top Braces

Cut notches in lining where cross bracing will be installed.
Glue in top lining only using 1 ” spring clamps. Make sure lining is glued in even with or slightly higher than the top edge of the side pieces when installed.
Cut and shape cross braces for Top and install in ‘ukulele. (Top only.)
After glue has dried, sand top of body (including blocks and bracing) flat for accepting sound board.

First <<
< Prev
Next >
>> Last

Ukulele Assembly Sequence
Constructing the ‘Ukulele Neck
Shaping of the Neck and Tail Blocks
Layout and Bending of ‘Ukulele Sides and Lining
Gluing Up of Top and Back of ‘Ukulele
Sanding and Shaping of Ukulele Sound Board and Back
Installing Neck onto ‘Ukulele Body
Glue in Top Lining and Top Braces
Gluing on Sound Board of the ‘Ukulele
Gluing in of Bottom Lining and Back Bracing
Gluing on Back of ‘Ukulele
Finishing Ukulele Surface
Making of Fret Board and Ukulele Bridge
Drilling of Holes for Ukulele Tuning Keys
Final Finishing of Ukulele

This entry was posted on Saturday, March 21st, 2009 at 4:38 pm and is filed under Build-Make an Ukulele. You can follow any responses to this entry through the RSS 2.0 feed. Both comments and pings are currently closed.